Xerox DocuColor 7000/8000 Digital Press with Creo CXP8000 Folheto
Powering Off and Powering On the CS Platform
™
Procedure
Stand-by Power Switch
Status LED
On / Off Switch
Figure 1
Note: Before the IOT is powered off, make sure the IOT is not in the Diagnostic Mode.
1. Power “Off” the IOT
2. Switch “Off” the CS Platform
2. Switch “Off” the CS Platform
™
using the On / Off Switch. (Figure 1)
3. Switch “Off” the Stand-by Power Switch.
4. Switch “On” the Stand-by Power Switch
5. Switch “On” the CS Platform
4. Switch “On” the Stand-by Power Switch
5. Switch “On” the CS Platform
™
using the On / Off Switch. The CS Platform will beep and
the Status LED should start to blink. This will take approximately 60 seconds.
6. Power “On” the IOT. Wait for the IOT to indicate that it is “Ready to Print”, before
resuming any CS Platform
™
activity.