Xerox WorkCentre 5865/5875/5890 Guia Do Administrador

Network Connectivity

Xerox

WorkCentre

5800/5800i Series Multifunction Printer

System Administrator Guide

For Configuration Settings, next to IP, click Edit.

To configure IPv4, click Show IPv4 Settings.

For Protocol, select Enabled.

For IP Address Resolution, select an option.

−

BOOTP: This option permits the printer to obtain an IP address from a BOOTP server that does

not respond to DHCP requests.

−

DHCP: This option permits the printer to obtain an IP address from a DHCP server. This option

permits the printer to obtain an IP address from a BOOTP server that is configured to accept

DHCP requests. The printer requests that the server register the IP address and hostname of

the printer with the DNS server.

−

STATIC: This option disables dynamic addressing and allows you to type a static IP address.

Type a Machine IP Address, Subnet Mask, and Gateway Address.

For Broadcast, select Enabled as needed.

Note:

If the printer does not obtain an IP address from a DHCP/BOOTP server, enable broadcast.

Enable broadcast when your DHCP/BOOTP server is on a different subnet than the printer and

communicates through a relay agent router.

For Zero-Configuration Networking, for Self Assigned Address, select Enable as needed. This option

instructs the printer to assign itself an address when a DHCP server does not provide one.

Click Apply.

Note:

If you select Default All, the printer disables FIPS 140 mode.

Configuring IPv6

IPv6 hosts can automatically configure themselves when connected to a routed IPv6 network using the

Internet Control Message Protocol Version 6 (ICMPv6). ICMPv6 performs error reporting for IP along

with other diagnostic functions. When first connected to a network, a host sends a link-local multicast

router solicitation request for configuration parameters. If suitably configured, routers respond to this

request with a router advertisement packet containing network-layer configuration parameters.
1.

In Xerox

CentreWare

Internet Services, click

Properties > Connectivity > Setup.

For Network, next to connection type, click Edit.

Note:

The printer uses separate IPv4, IPv6, and DNS settings for wired and wireless network

connections. Before you configure wireless IP settings, install the Xerox

Wireless Network Interface,

then connect to a wireless network. For details, see

Connecting to a Wireless Network

on page 32.

For Configuration Settings, next to IP, click Edit.

To configure IPv6, click Show IPv6 Settings.

Note:

If both IPv4 and IPv6 are disabled, you cannot access Xerox

CentreWare

Internet Services.

To access IPv4 and IPv6 settings in Xerox

CentreWare

Internet Services, enable IPv4, IPv6, or

both, at the printer control panel. If you disable IPv4 and IPv6 or change the IP addresses, any

dependent protocols are disabled.