Xerox Xerox Secure Access Unified ID System Support & Software Guia Do Administrador

Secure Access Overview

Xerox Secure Access Administration Guide

21

To enter data using a proximity card or smart card, pass the card within 1 inch or 2.5 cm of the 
proximity symbol located on the top of the card reader device. To locate the proximity card reader on 
the data reader module, look for this symbol:

If the swipe is invalid, the LED flashes red.

Card Reader Signals and Modes

Secure Access displays its messages through an LED on the card reader module.

The LED behavior is the same for both types of Card Readers except where noted. The following signals 
may be displayed:

Solid Red

Authentication Subsystem is in Idle mode; it is ready but there is no active session.

Solid Green

Authentication Device is in Ready mode and a session is active. This state will also 
occur if using a USB card reader while the MFP is booting and the Network controller 
has not yet been initialized.

Slow flashing green

Data received from card reader, awaiting authentication for active session or user 
input (e.g. card self-registration or at the Release All Jobs prompt).

Slow flashing red

Authentication Subsystem has no connection to server.

Fast flashing red

Invalid card; access denied.