Xerox Phaser 8500/8550 Folheto

To save energy, the printer enters a Power Saver, low-energy consumption mode after a pre-
defined period of time since its last activity. In this mode, most printer electrical systems are 
shut down. When a print job is sent to the printer, the printer enters Warmup mode. You can 
also warm up the printer by pressing the OK button on the control panel.

If you find that the printer is going into Power Saver mode too often and you do not want to 
wait while the printer warms up, increase the length of time before the printer goes into Power 
Saver mode.

To change the Power Saver Timeout value, use one of the following options:

■

The printer’s control panel

■

CentreWare IS

 

To change the Power Saver Timeout value on the control panel:

Select 

, and then press the OK button.

Select 

, and then press the OK button.

Select 

, and then press the OK button.

Press the Up Arrow or Down Arrow button to scroll to a selected Power Saver Timeout 
value. Select a larger value if you want to extend the length of time before the printer goes 
into Power Saver mode.

Press the OK button.

 

To change the Power Saver Timeout value using CentreWare IS:

Launch your web browser.

Enter your printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).

Click Properties.

Select the General folder on the left sidebar, and then click Warmup.

Select a value from the Power Saver Timeout drop-down list.

Click the Save Changes button at the bottom of the page.