Xerox Phaser 790 Guia Do Utilizador
Network Problem Solving
23. Problem Solving
Xerox Phaser 790
23-37
Network Problem Solving
Because the Phaser 790 server is part of the Printer, most references in this
chapter are simply to the Printer. The word server is used to refer to network
servers.
chapter are simply to the Printer. The word server is used to refer to network
servers.
Troubleshooting during Setup from the Control Panel
If you have difficulty printing the test page and no message is displayed,
perform the following steps:
perform the following steps:
1.
Check the Printer status.
2.
Use the table below to attempt to resolve the problem.
3.
Try printing again.
Symptom
Possible cause
Possible solution
The power switch is not
switched on.
switched on.
Switch ON the Printer
power switch.
power switch.
The power cord is not
securely attached.
securely attached.
Ensure that the power
cord is securely plugged
into the wall and into the
Printer.
cord is securely plugged
into the wall and into the
Printer.
None of the control
panel lights are on.
Nothing is displayed on
the Control Panel
Screen.
panel lights are on.
Nothing is displayed on
the Control Panel
Screen.
There is no power to the
electrical outlet.
electrical outlet.
Ensure that the outlet is
switched on.
switched on.
The network cable or the
parallel cable is not
securely connected.
parallel cable is not
securely connected.
Ensure that the network
cable or the parallel cable
connector is securely
attached.
cable or the parallel cable
connector is securely
attached.
The In Progress light is
not lit during a network
print job, or a copy job is
in progress.
not lit during a network
print job, or a copy job is
in progress.
Either the print driver is
not installed or a server
has is not correctly set
up.
not installed or a server
has is not correctly set
up.
Check the settings on the
host server.
host server.