Craftsman 3100iSC Manual Do Utilizador
![Craftsman](https://files.manualsbrain.com/attachments/64d6cde975b4a3b8237659498f8efc460daae72a/common/fit/150/50/86e49e5c9c65cca0b47572681506b669ff7da60b30985782de01b2359a72/brand_logo.png)
About the Diagnostic Tool
BATTERY REPLACEMENT
6 47177
On some Asian and European vehicles the DLC is located
behind the “ashtray” (the ashtray must be removed to access it)
or on the far left corner of the dash. If the DLC cannot be
located, consult the vehicle’s service manual for the location.
behind the “ashtray” (the ashtray must be removed to access it)
or on the far left corner of the dash. If the DLC cannot be
located, consult the vehicle’s service manual for the location.
BATTERY REPLACEMENT
Replace batteries when the battery symbol is visible on display
and/or the 3 LEDS are all lit and no other data is visible on screen.
and/or the 3 LEDS are all lit and no other data is visible on screen.
1.
Locate the battery cover on the back of the diagnostic tool.
2.
Using a Phillips head screwdriver, remove the screw from the
battery cover.
3.
Slide the battery cover off (use your fingers).
4.
Replace batteries with three AA-size batteries (for longer life, use
Alkaline-type batteries).
5.
Reinstall the battery cover and screw on the back of the diagnostic
tool.
Adjustments After Battery Installation
The first time the unit is turned on, you must select the desired display
language (English, French or Spanish) and unit of measurement (USA
or Metric) as follows:
language (English, French or Spanish) and unit of measurement (USA
or Metric) as follows:
1.
Press the POWER/LINK button to turn
the diagnostic tool “ON.”
The Select Language screen
displays.
displays.
2.
Use the UP
and DOWN
buttons,
as necessary, to highlight the desired
display language.
display language.
3.
When the desired display language is
selected, press the ENTER
button to
confirm your selection.
The Select Unit screen displays.
4.
Use the UP
and DOWN
buttons,
as necessary, to highlight the desired
unit of measurement.
unit of measurement.
5.
When the desired unit of measurement is selected, press the
ENTER
button to confirm your selection.
After the initial language and unit of measurement selections
are performed, these, as well as other settings, can be
changed as desired. Proceed to “ADJUSTMENTS AND
SETTINGS” on page 74 for further instructions.
are performed, these, as well as other settings, can be
changed as desired. Proceed to “ADJUSTMENTS AND
SETTINGS” on page 74 for further instructions.