Craftsman 25926 Manual Do Utilizador

6 — English

Do not allow familiarity with products 

to make you careless. Remember that a careless 
fraction of a second is sufficient to inflict serious 
injury.

Always wear eye protection with side 

shields marked to comply with ANSI Z87.1. Failure to 
do so could result in objects being thrown into your 
eyes resulting in possible serious injury.

 Do not use any attachments or 

accessories not recommended by the manufacturer 
of this product. The use of attachments or 
accessories not recommended can result in serious 
personal injury.

You may use this product for the purpose listed below:
 

Charging compatible 12 Volt - 19.2 Volt Craftsman

® 

battery packs

If at any point during the charging 

process none of the LEDs are lit, remove the 
battery pack from the charger to avoid damaging 
the product. DO NOT insert another battery. Return 
the charger and battery to your nearest authorized 
service center for service or replacement.

Charge in a well ventilated area. Do not 

block charger vents. Keep them clear to allow proper 
ventilation.



  Red LED on, Green LED off = Power to charger is on.



  Red LED flashing, Green LED off = Battery is being 

tested.



  Red LED fading, Green LED off = Battery is defective. 



  Red LED on, Green LED flashing = Battery is charging.



  Red LED off, Green LED on = Battery is fully charged.



  Red LED off, Green LED fading on and off = Battery 

is fully charged; charger is in Energy Save mode. 
Charger will periodically wake from Energy Save mode 
to ensure the battery pack remains in a fully charged 
state.

Battery packs are shipped in a low charge condition to 
prevent possible problems. Therefore, you should charge 
them before first use. If the charger does not charge the 
battery pack under normal circumstances, return both the 
battery pack and charger to your nearest repair center for 
electrical check.


  Make sure the power supply is normal household 

voltage, 

120 volts, AC only, 60 Hz.



  Connect the charger to a power supply.



  Attach the battery pack to the charger by aligning the 

raised ribs on the battery pack with the grooves in the 
charger, then slide the battery pack onto the charger.



  Press down on the battery pack to be sure contacts on 

the battery pack engage properly with contacts in the 
charger. 



  Latches should snap into place to ensure battery is 

correctly connected.



  Do not place the charger in an area of extreme heat or 

cold. It will work best at normal room temperature. 

  NOTE: The charger and battery pack should be placed 

in a location where the temperature is more than 50°F 
but less than 96°F.



  The battery pack will become slightly warm to the 

touch while charging. This is normal and does not 
indicate a problem.



  After charging is complete, the green LED will remain 

on for one hour, indicating Maintenance Mode.



  After completing maintenance mode, the green LED 

will begin fading on/off continuously. This indicates the 
battery is fully charged and the charger is in Energy 
Save Mode.



  Charger will periodically wake from Energy Save mode 

to ensure the battery pack remains in a fully charged 
state.

 

To remove the battery pack from the charger, depress 
the latches on both sides of the battery pack and pull 
up on the battery pack.

When using a tool continuously, the battery pack may 
become hot. A hot battery pack may be placed directly 
onto the charger port but charging will not begin until 
the battery temperature cools to within acceptable 
temperature range. When a hot battery pack is placed 
on the charger, the red LED will begin flashing and the 
green LED will be off. When the battery pack cools to 
approximately 120°F (40°C), the charger will automatically 
begin charging.