Honeywell HE360 Guia Da Instalação

9

69-2517EF—01

Water leakage

Leaking joints.

Shut off water.
Tighten connections.

Brass tubing inserts

Verify that brass tubing inserts are used.

Saddle valve leaking.

Verify rubber pad is installed on saddle valve.

No water to drain.

Verify control circuit wiring.
Check all connections.

Humidistat

Turn humidistat up and down and listen for contact 
to click.

Humidifier power

Verify that outlet has power.

Solenoid

After verifying other wiring components, turn on 
furnace fan, turn humidistat up and down, and listen 
for solenoid to click.

Verify plumbing connections.
Check for kinks.

Saddle valve

Verify that needle pierces water line and then backs 
out needle to open valve.

Humidifier

Remove cover and verify that water flows into 
distribution tray.

Drain tubing

Verify no obstructions.

Low humidity

Furnace blower not operating.

• Reset circuit breaker or check for blown fuse.
• Check that the furnace power is on.
• Check all external wiring connections.
• Check the humidity control setting.
• Call a professional heating contractor.

Rapid air changes. Drafts (cold 
air is dry and is an added load 
to the humidifier).

• Keep doors and windows closed.
• Close fireplace damper when not in use.
• Keep exhaust fan running time to a minimum.
• Seal around doors and windows.

High humidity

Condensation on walls.

• Turn off humidity control and water until 

condensation is completely evaporated.

Heavy condensation on 
windows.

• Turn humidity control down low enough to 

eliminate condensation caused by moisture from 
bathing, mopping, cooking, etc. If moisture 
persists, more ventilation is needed.