Zanussi ZRA21600WA Manual Do Utilizador

The door is not closed correct-

ly.

Refer to "Closing the door".

Water flows inside the refrigera-

tor.

The water outlet is clogged.

Clean the water outlet.

Food products prevent that

water flows into the water col-

lector.

Make sure that food products do

not touch the rear plate.

Water flows on the floor.

The melting water outlet is not

connected to the evaporative

tray above the compressor.

Attach the melting water outlet to

the evaporative tray.

Door is misaligned or interferes

with ventilation grill.

The appliance is not levelled.

Refer to "Levelling".

The temperature in the appliance

is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower temperature.

The door is not closed correct-

ly.

Refer to "Closing the door".

The food products' tempera-

ture is too high.

Let the food products temperature

decrease to room temperature be-

fore storage.

Many food products are stored

at the same time.

Store less food products at the

same time.

The door has been opened of-

ten.

Open the door only if necessary.

There is no cold air circulation

in the appliance.

Make sure that there is cold air cir-

culation in the appliance.

If the advice does not lead to the

desired result, call the nearest

brand-mark service.

Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.

2. Remove the lamp cover (refer to the

illustration).

3. Replace the used lamp with a new lamp of

the same power and specifically designed

for household appliances (the maximum

power is shown on the lamp cover).

4. Install the lamp cover.

5. Tighten the screw to the lamp cover.

6. Connect the plug to the mains socket.

7. Open the door.

Make sure that the light comes on.