Zanussi ZCI68330XA Manual Do Utilizador

You can install your freestanding appliance with

cabinets on one or two sides and in the corner.

Minimum distances

A

2

B

685

Use small feet on the bottom of appliance to set

the appliance top surface level with other

surfaces.

Adjust the appliance to the correct height and

put it in the correct area before you attach the

anti-tilt protection.

Install the anti-tilt protection to

prevent the appliance from falling

under incorrect loads. The anti-tilt

protection only works when the

appliance is put in a correct area.

The anti-tilt protection has two parts (A + B).

You can find the anti-tilt protection (B) on the

right or left side of the rear wall of the appliance.

1. Install the anti-tilt protection (A) on the wall. 

Make sure that the wall is made of a solid

material. If not, you need to make the wall

sufficiently strong to hold the weight.

Make sure that the surface behind the

appliance is smooth.

2. Put the appliance in the middle of the space

between the cupboards. 

If the space is larger than the width of the

appliance, you must adjust the side

measurement.

3. Install the anti-tilt protection (A)

approximately 77 mm below the top surface

of the appliance and 50 mm from the left or

right side of the appliance into the circular

hole on the bracket. Screw it into the wall.

50 mm

77 mm

4. Check that the anti-tilt protection (A) fits

minimum 20 mm into the hole in the rear

wall of the appliance (B) when you push the

appliance.