Cisco Cisco UCS B260 M4 Blade Server Manual Técnico
Configure VMM Domain Integration with ACI and
UCS B Series
UCS B Series
Document ID: 118965
Contributed by Joseph Ristaino, Cisco TAC Engineer.
Nov 10, 2015
Contents
Introduction
Prerequisites
Requirements
Components Used
Configure
Create the VMM Domain
Verify the DVS is Created in vCenter
Create/Verify that CDP or LLDP is Enabled on the UCS vNICs
Configure the vSwitch Policies on APIC for UCS B
Verify
Troubleshoot
Prerequisites
Requirements
Components Used
Configure
Create the VMM Domain
Verify the DVS is Created in vCenter
Create/Verify that CDP or LLDP is Enabled on the UCS vNICs
Configure the vSwitch Policies on APIC for UCS B
Verify
Troubleshoot
Introduction
This document describes the configuration steps you use in order to integrate a Cisco Unified Computing
System (UCS) B Series into an Application Centric Infrastructure (ACI) fabric that leverages Virtual Machine
Manager (VMM) domain integration.
System (UCS) B Series into an Application Centric Infrastructure (ACI) fabric that leverages Virtual Machine
Manager (VMM) domain integration.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these hardware and software versions:
An ACI fabric that consists of two spine switches and two leaf switches
•
A UCS B Series chassis with two fabric interconnects
•
UCS B Series blades with VMware ESXi
•
An Application Policy Infrastructure Controller (APIC)
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.