Cisco Cisco MDS 9000 SAN-OS Software Release 1.0 Guia Da Instalação

Cisco MDS 9000 NX-OS Software Upgrade and Downgrade Guide, Release 5.2(x)

OL-25746 -01, Cisco MDS 9000 NX-OS Release 5.2(x)

Migrating From Supervisor-1 Modules to Supervisor-2 Modules

Step 6

Activate the zone set.

switch# config

zoneset activate name backendzonesetname vsan

Check to see if the CVT zones are active by entering the show zoneset active command.

Step 7

Recreate the DVTs. Locate the DVTs by entering the following command:

switch# show santap module x dvt

To recreate each DVT, enter these commands:

switch# config

santap module

x dvt target-pwwn backend storage pwwn

target-VSAN

backend VSAN dvt-name name for the dvt dvt-vsan Front end VSAN for this DVT

LUN-size-handling 1

Step 8

Host-to-target zones are already configured in front-end and back-end VSANs so the paths should be up
now. Rescan the hosts for disks.

Step 9

Rescan SAN on the RPAs. Log in to the RPA1 CLI using the ssh or telnet command and log in as the
admin user.

switch# rescan_San

Enter the site name, or press Enter for both sites.

rpa1

Rescan SAN volumes?

A 'full' rescan can take several minutes (default is basic)

1) full

2) basic

3) none

Select, or press 'ENTER': 1

Rescan SAN splitters? (default is yes)

1) yes

2) no

Select, or press 'ENTER': 1

If you are rescanning the splitters, enter the splitter name. Also rescan the splitter volume connections.
The default is set to all.

Step 10

Rescan the splitters in the RP GUI and add a new splitter.

Step 11

Remove the original AVT zones from the zone set.

Note

Generation 3 RPAs only have a single AVT zone instead of separate initial and target AVT zones.

switch# config

zoneset name backendzonesetname vsan

no member avt-init zone name

no member avt-target zone name

exit

Activate the zone set to remove the members.

Step 12

On RPA, configure the new AVT zones: