Cisco Cisco Unified MeetingPlace 5.3 Manual De Manutenção
8
CD Tray Replacement Procedure for the Cisco MeetingPlace 8106
OL-6461-01
How To Replace the CD Tray
Step 3
Slide the CD tray into the CD tray slot until it stops.
Step 4
Use your thumbs to press the CD tray into place so that the front panel of the CD tray is flush with the
Cisco MeetingPlace 8106 chassis.
Cisco MeetingPlace 8106 chassis.
Caution
Do not force the CD tray into the slot. This can damage the CD tray and the Cisco MeetingPlace 8106
chassis.
chassis.
Step 5
Use a Phillips screwdriver to tighten the two outer screws that secure the CD tray to the
Cisco MeetingPlace 8106 chassis.
Cisco MeetingPlace 8106 chassis.
Powering Up the Cisco MeetingPlace 8106
Step 1
Plug the power cable into the back of the Cisco MeetingPlace 8106.
Step 2
Locate the power switch on the back of the Cisco MeetingPlace 8106 and turn it to the on position (“ | ”).
Step 3
Start the terminal emulator program on your computer. See the
for information about how to start the terminal emulator program.
Step 4
Access the CLI.
Step 5
Log in as an administrator. The tech$ prompt appears.
Step 6
To ensure that the new CD tray is working properly, enter hwconfig. Output similar to the following
example appears:
example appears:
meetingplace:tech$ hwconfig
Cabinet: ELMA
4U
Bus architecture:
CompactPCI
Processor card:
SMM5370LATUDE S/N=6055691
Processor:
Pentium III, Model 8, 700 MHz
Memory:
512 MB
Temperature:
22C
Voltages:
3.34V, 5.02V, 12.00V
Power Supplies:
OK
Fans:
OK
SCSI Adapter:
NCR 810
DISK 1:
36000MB (SEAGATE ST336607LC REV=0005)
DISK 2:
36000MB (SEAGATE ST336607LC REV=0005)
121612