Cisco Cisco Catalyst 6500 Series 7600 Series Wireless Services Module (WiSM) Guia De Resolução De Problemas

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Background Information
 Overview of Cisco WiSM integration
 Overview of VSS and Cisco WiSM
      Control Path or OBC protocol
      HA
      Packet Flow
 Administration of a Cisco WiSM in VSS Switch
      Configuration Changes for Cisco WiSM in VSS mode
      Configuring Communication between the Supervisor 720 and Cisco WiSM
 Related Information

This document explains how to integrate the Cisco WiSM with the Cisco Virtual Switching System (VSS).

This feature relies on an understanding of VSS concepts. Therefore it is highly recommended to review the
relevant materials before you read this document. There is a brief description of VSS in this paper, but it is not
meant to be a comprehensive explanation of it.

Refer to the Understanding Virtual Switching Systems section of Catalyst 6500 Release 12.2SXH and Later
Software Configuration Guide for more information on VSS.

The information in this document is based on these software and hardware versions:

Minimum Software Release: Supervisor 720 release 12.2(33) SXI and above

• 

Cisco WiSM Software 4.2.130.0 or later

• 

It is possible to support a maximum of five Cisco WiSM blades in a single chassis in VSS mode.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.