Cisco Cisco Email Security Appliance C170 Guia Da Instalação

2-7

Cisco 380 and Cisco 680 Series Hardware Installation Guide

OL-29172-01

Chapter

Figure 2-2

Inserting the Appliance Into the Slide Rails

Connecting the Interface Cables and Verifying Connectivity

This section describes how to connect the cables to the console and anagement ports.

Warning

Only trained and qualified personnel should install, replace, or service this equipment

Statement 49

Caution

Read the safety warnings in the

Regulatory Compliance and Safety Information for Cisco Content

Security Appliances

and the

Safety and Compliance Guide for Cisco IronPort Appliances

and follow

proper safety procedures when performing any tasks in this document.

To connect cables to the ports, perform the following steps:

Step 1

Place the appliance on a flat, stable surface, or in a rack (if you are rack-mounting it).

Step 2

Before connecting a computer or terminal to the ports, determine the baud rate of the computer console port.
The baud rate must match the default baud rate (9600 baud) of the console port of the Cisco 380 and Cisco
680 Series appliance. Set up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop bits,
and Flow Control (FC) set to Hardware.

Step 3

Connect the cables to the ports.

Management port—For more information, see the figures in

PCI NIC Slot Configurations, page 1-4

for illustrations of the management port on the Cisco 380 and Cisco 680 appliance.