Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Guia De Resolução De Problemas
Components Used
The information in this document is based on Cisco ONS 15454 Release 3.10 software (Release
3.10−001K−17.01).
3.10−001K−17.01).
The information presented in this document was created from devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If you are working in a live
network, ensure that you understand the potential impact of any command before using it.
devices used in this document started with a cleared (default) configuration. If you are working in a live
network, ensure that you understand the potential impact of any command before using it.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Create VT and VTT Tunnels
Note: If you are concerned about consistent bandwidth management, it is recommended you create two VTT
tunnels manually in order to allow the tunnels to transverse each node and maximize the VT matrix in each
node.
tunnels manually in order to allow the tunnels to transverse each node and maximize the VT matrix in each
node.
Step 1: UPSR Tunnels Scenario − Four−Node UPSR Ring
In this example, you start with a four−node UPSR with a tunnel created from nodes B to D.
Under Circuits, create and name your circuit and then choose Type. In this case, it is a VT tunnel.
Click Next.
Click Next.
1.
Choose the source node and then the destination node.
In this example, you can see that the VTT from source node B goes to destination node D.
2.