Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Guia Da Instalação
3
Installing Gigabit Interface Converters in the E1000-2, E1000-2-G, and G1000-4 Cards
78-11404-02
GBIC Installation
GBIC Installation
GBICs are hot-swappable and can be installed and removed while the card/shelf assembly is powered
and running. This section provides installation procedures for GBICs with clips and GBICs with handles.
and running. This section provides installation procedures for GBICs with clips and GBICs with handles.
Warning
Before you install, operate, or service the system, read the Site Preparation and Safety Guide. This
guide contains important safety information you should know before working with the system.
guide contains important safety information you should know before working with the system.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
GBICs are Class I laser products. These products have been tested and comply with Class I limits.
Warning
Because invisible laser radiation may be emitted from the aperture of the port when no cable is
connected, avoid exposure to laser radiation and do not stare into open apertures.
connected, avoid exposure to laser radiation and do not stare into open apertures.
Warning
Ultimate disposal of this product should be handled according to all national laws and
regulations.
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
touch the backplane with your hand or any metal tool, or you could shock yourself.
Caution
Only use GBICs certified for use in the ONS 15454; Cisco product numbers 15454-GBIC-SX,
15454-GBIC-LX, and 15454-GBIC-ZX. Cisco TAC does not support third-party GBICs, for example,
any GBIC module that is not sourced from Cisco directly, or via a Cisco Partner or Cisco authorized
seller. Cisco-sourced GBICs can be identified by the Cisco label and logo.
15454-GBIC-LX, and 15454-GBIC-ZX. Cisco TAC does not support third-party GBICs, for example,
any GBIC module that is not sourced from Cisco directly, or via a Cisco Partner or Cisco authorized
seller. Cisco-sourced GBICs can be identified by the Cisco label and logo.
Note
GBICs must be matched on either end by type: SX to SX, LX to LX, or ZX to ZX.
Installing a GBIC with Clips
Step 1
Remove the GBIC from its protective packaging.
Step 2
Check the label to verify that the GBIC is the correct type (SX, LX, or ZX) for your network.
Step 3
Verify that you are installing compatible GBICs; for example, SX to SX, LX to LX, or ZX to ZX.
Step 4
Grip the sides of the GBIC with your thumb and forefinger and insert the GBIC into the slot on the
E1000-2/E1000-2-G/G1000-4 card (shown in
E1000-2/E1000-2-G/G1000-4 card (shown in
Note
GBICs are keyed to prevent incorrect installation.