Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP)
3
Release Notes for Cisco ONS 15454 Release 5.0.5
OL-8073-01
Changes to the Release Notes
Changes to the Release Notes
This section documents supplemental changes that have been added to the Release Notes for Cisco ONS
15454 Release 5.0.5 since the production of the Cisco ONS 15454 System Software CD for Release
5.0.5.
15454 Release 5.0.5 since the production of the Cisco ONS 15454 System Software CD for Release
5.0.5.
The following changes have been added to the release notes for Release 5.0.5.
Changes to Caveats
The following caveats have been added.
Changes to Resolved Caveats
The following caveat has been resolved.
Caveats
Review the notes listed below before deploying the ONS 15454. Caveats with DDTS tracking numbers
are known system limitations that are scheduled to be addressed in a subsequent release. Caveats without
DDTS tracking numbers are provided to point out procedural or situational considerations when
deploying the product.
are known system limitations that are scheduled to be addressed in a subsequent release. Caveats without
DDTS tracking numbers are provided to point out procedural or situational considerations when
deploying the product.
Software Upgrades
DDTS # CSCei29741
On nodes with DS3/EC1-48 cards, where port line buildouts are set to long (for use with 900 ft cables),
a software upgrade from Release 5.0 or maintenance Release 5.0.2 to any release after 5.0.2 can result
in traffic hits up to 50 ms on the ports set to long line buildout. The length of the hit depends on the
operative slot, port, actual cable length, UBIC type, and cable type. This issue cannot be resolved for
upgrades from the two affected releases. No other release has this issue, and upgrades from Release 5.0
to 5.0.2 are also not affected.
a software upgrade from Release 5.0 or maintenance Release 5.0.2 to any release after 5.0.2 can result
in traffic hits up to 50 ms on the ports set to long line buildout. The length of the hit depends on the
operative slot, port, actual cable length, UBIC type, and cable type. This issue cannot be resolved for
upgrades from the two affected releases. No other release has this issue, and upgrades from Release 5.0
to 5.0.2 are also not affected.
Hardware
DDTS # CSCed18803
Rarely, the non-enhanced Muxponder unit does not pass Jitter Tolerance test from Trunk port to client
port as per ITU-T G.825, 2 Mb/s mask, at the 10 Hz specific setpoint. The Muxponder should be
configured with G.709 Off, FEC Off and Trunk signal provided by external Jitter test box, and the unit
port as per ITU-T G.825, 2 Mb/s mask, at the 10 Hz specific setpoint. The Muxponder should be
configured with G.709 Off, FEC Off and Trunk signal provided by external Jitter test box, and the unit