Cisco Cisco Unified MeetingPlace Audio Server Manual De Manutenção
4-30
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 4 Configuring the 8112 Server
Configuring the system
Table 4-5
Default T1 CAS Span Configuration
Parameter
Default
Explanation
Possible Values
X
Activate the DTI
span?
span?
y
Specifies if the span is active.
•
y = active
•
n = inactive
Framing
ESF
Specifies the framing
protocol used on this span.
Determined by the service
provider.
protocol used on this span.
Determined by the service
provider.
We recommend using ESF
only.
only.
•
D4
•
ESF
Zero code
suppression
suppression
B8ZS
Specifies the zero code
suppression for the span.
Determined by the service
provider.
suppression for the span.
Determined by the service
provider.
We recommend using B8ZS
only.
only.
•
none
•
B8ZS
•
jammed bit
Timing
external
Specifies if MeetingPlace
should get clock timing from
the PBX/Central Office or if
timing is generated by
MeetingPlace.
should get clock timing from
the PBX/Central Office or if
timing is generated by
MeetingPlace.
At least one span should
always be designated
external.
always be designated
external.
•
internal
•
external (the span
is connected to
the public
network or a
trusted system)
is connected to
the public
network or a
trusted system)
External sync
priority
priority
none.
The T1 span
connected to the
T1 Smart Blade
in slot 1, line A
gets sync priority
1, line B gets 2,
etc.
connected to the
T1 Smart Blade
in slot 1, line A
gets sync priority
1, line B gets 2,
etc.
Specifies the priority of the
spans that are set for external
timing. The system always
tries to synchronize from the
highest priority span. If the
synchronization span goes
down, the system
automatically switches
synchronization to the next
highest span. If a higher
priority span comes up, the
system automatically
synchronizes off of it.
spans that are set for external
timing. The system always
tries to synchronize from the
highest priority span. If the
synchronization span goes
down, the system
automatically switches
synchronization to the next
highest span. If a higher
priority span comes up, the
system automatically
synchronizes off of it.
•
1-255 (1 is the
highest, 255 is the
lowest)
highest, 255 is the
lowest)
•
never
Trunk [x]
Numbering is
done in order (1,
2, 3, etc.). For
example,
done in order (1,
2, 3, etc.). For
example,
Trunk [1]:port 0
Trunk [2]:port 1
Trunk [3]:port 2
Specifies which port in the
database is assigned to the
specific hardware trunk on
the card.
database is assigned to the
specific hardware trunk on
the card.
•
number