Cisco Cisco Unified MeetingPlace Audio Server Manual De Manutenção
4-57
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
Figure 4-61 blade Command Jitter Buffer Configuration
Note
This configuration must be done for each Multi Access Blade used for an IP configuration.
Configuring the IP system
This section explains how to configure Multi Access Blades and Smart Blades for a pure IP
configuration. If this is part of a T1 CAS system, refer to the
configuration. If this is part of a T1 CAS system, refer to the
. If this is part of a T1 PRI system, refer to the
. If this is part of an E1 system, refer to the
If this is part of a mixed configuration, refer to the
The “blade” command is used to configure all ports. Follow the procedure below to configure the
necessary Multi Access Blades and Smart Blades. Refer to the examples following this section for more
detailed information. For more information about the “blade” command, see the
necessary Multi Access Blades and Smart Blades. Refer to the examples following this section for more
detailed information. For more information about the “blade” command, see the
***** B L A D E C O N F I G M E N U *****
1) View blade details
2) Modify blade
x) Exit program
Enter command: 2
Enter blade slot [1..6]: 6
Type [IP]:
Card Type [TP1610]:
Port Group [ 1]:
Number of Ports [120]:
1st Port [ 23]:
IP address [0] [10.10.10.10]:
Subnet Mask [255.255.255.0]:
Default Gateway [10.10.10.1]:
Base UDP Port [0] [ 5000]:
Jitter Buffer Minimum Size [ 100]: 150
Jitter Buffer Optimization [ 7]: 9
IP Precedence [0]:
Type of Service (TOS) [ 0]:
DSCP / DiffServ [unused]:
RTCP Interval [default]: