Cisco Cisco D9824 Advanced Multi Decryption Receiver Guia Da Instalação
Connecting the Input/Output Signals
27
Note: Proper cables are required for reliable Ethernet operation; to run up to a
maximum segment length of 100 m and up to 100baseT, the cable has to comply with
the EIA/TIA Category 5 (or higher) wire specifications, and for 1000baseT, Category
6 is required. For EMC protection, shielded cables must be used.
1 Connect an RJ-45 cable between the Ethernet connector on the D9824 receiver
maximum segment length of 100 m and up to 100baseT, the cable has to comply with
the EIA/TIA Category 5 (or higher) wire specifications, and for 1000baseT, Category
6 is required. For EMC protection, shielded cables must be used.
1 Connect an RJ-45 cable between the Ethernet connector on the D9824 receiver
and the Ethernet port of your PC.
2 Set up the IP address on the D9824 receiver (via the front panel display). For
information on setting up the IP address via the front panel, see Setting up for
Network Connection (on page 13).
Network Connection (on page 13).
Connecting the ASI Output
Connect the output signal from the D9824 receiver ASI OUT connector.
Use a Belden “Brilliance” cable with foil/braid construction. The shield must
provide 99% or better shielding effectiveness.
provide 99% or better shielding effectiveness.
The equipment after the D9824 receiver could be a Cisco D9887 HDTV Receiver.
External Alarm System Connector
The D9824 receiver and Alarm relay functionality. See Connecting the Cue Tone/Cue
Trigger Interface (on page 29) for more information on Cue Tone and Cue Trigger
equipment connections. These outputs are user-configurable via the Setup Menu on
the front panel.
Trigger Interface (on page 29) for more information on Cue Tone and Cue Trigger
equipment connections. These outputs are user-configurable via the Setup Menu on
the front panel.
The Alarm output connector is a 15-pin sub-D female connector. The following
diagram shows the connector and the pin allocation table for the Alarm output pins.
diagram shows the connector and the pin allocation table for the Alarm output pins.
The connector pin states depend on the selected Relay Mode. The Relay Mode is set
on the front panel via the Main: Setup: Outputs menu.
on the front panel via the Main: Setup: Outputs menu.
Changing the Relay Mode for Alarm Monitoring
The Alarm relay is a program relay that can be configured to provide programmed
responses for alarms, warnings, cue trigger states for ad-insertion equipment, or a
cue tone output for connection to ad-insertion equipment. As a default, the Alarm
Relay is configured for Alarm mode.
1 On the front panel menu, go the Main: Setup: Outputs, and select Cueing.
responses for alarms, warnings, cue trigger states for ad-insertion equipment, or a
cue tone output for connection to ad-insertion equipment. As a default, the Alarm
Relay is configured for Alarm mode.
1 On the front panel menu, go the Main: Setup: Outputs, and select Cueing.
2 Use the down arrow key to scroll through the menu to Relay Mode.
3 Change the state to Alarm and press the Select key to save the new setting. As a
3 Change the state to Alarm and press the Select key to save the new setting. As a
result, the rear panel connector pin states will change to that shown in the table
below for Alarm mode.
below for Alarm mode.