Cisco Cisco Flex 7510 Wireless Controller Referências técnicas
3
Flex 7500 Wireless Branch Controller Deployment Guide
Product Specifications
Network Interface Ports
Note:
LAG support for 2x10G interfaces allows active-active link operation with fast failover link redundancy. An
additional active 10G link with LAG does not change the controller wireless throughput.
2x10G interfaces.
2x10G interfaces support optic cable with SFP product # SFP-10G-SR and SFP-10G-LR.
Switch side SFP or X2 product should be of the same type SR or LR.
System MAC Addresses
Serial Console Redirect
The WLC 7500 enables console redirect by default at the baud rate of 9600, simulating Vt100 terminal with no flow
control.
control.
Inventory Information
The following is the WLC 7500 Console:
(Cisco Controller) >show inventory
Burned-in MAC Address............................ E4:1F:13:65:DB:6C
Maximum number of APs supported.................. 2000
NAME: "Chassis" , DESCR: "Cisco Wireless Controller"
PID: AIR-CT7510-K9, VID: V01, SN: KQZZXWL
The Desktop Management Interface (DMI) table contains server hardware and BIOS information. The WLC 7500 displays
BIOS version, PID/VID and Serial Number as part of inventory.
BIOS version, PID/VID and Serial Number as part of inventory.
Interface Ports
Usage
Fast Ethernet
Integrated Management Module (IMM)
Port 1: 1G
WLC Service Port
Port 2: 1G
WLC Redundant Port (RP)
Port 1: 10G
WLC Management Interface
Port 2: 10G
WLC Backup Management Interface Port (Port
Failure)
Failure)
Port 1: 10G (Management Interface)
System/Base MAC address
Port 2: 10G (Backup Management
Interface)
Interface)
Base MAC address+5
Port 1: 1G (Service Port)
Base MAC address+1
Port 2: 1G (Redundant Port)
Base MAC address+3