Cisco Cisco IOS Software Releases 12.2 MC

Página de 18
 
2
Release Notes for Cisco MWR 1941-DC Mobile Wireless Edge Router for Cisco IOS Release 12.2(15)MC1
OL-13984-06
Introduction
Introduction
The Cisco MWR 1941-DC Mobile Wireless Edge Router running Cisco IOS Release 12.2(8) MC2 or a 
later Cisco IOS 12.2 MC software release is a networking platform optimized for use in mobile wireless 
networks. It extends IP connectivity to the cell site and Base Transceiver Station (BTS), and through a 
Fast Ethernet interface to the BTS, provides bandwidth-efficient IP transport of voice and data bearer 
traffic, as well as maintenance, control, and signalling traffic, over the leased line backhaul network 
between the BTS and leased line termination and aggregation node via compression (cRTP/cUDP) and 
packet multiplexing (PPPMux and MLPPP). It supports a limited set of interfaces and protocols, but 
offers high performance at a low cost while meeting the critical requirements for deployment in cell 
sites, including small size, extended operating temperature range, high availability, and DC input power 
flexibility. 
System Configuration Requirements 
The Cisco MWR 1941-DC Mobile Wireless edge router requires the following system configuration:
Cisco IOS 12.2(8) MC2 or a later Cisco IOS Release 12.2 MC software be installed.
Network Time Protocol (NTP) 
Network Time Protocol must be configured. The Cisco MWR 1941-DC router uses NTP to maintain 
a clocking source for the proper time stamping of system messages and log files.
Redundancy
When not using the Cisco MWR 1941-DC router in a redundant configuration, the standalone option 
must be configured from redundancy mode. 
When using the Cisco MWR 1941-DC router in a redundant configuration:
Keepalives under the FE must be set to 1.
Extended Availability Drop and Insert (EADI) capabilities must be disabled on the router (using 
the disable-eadi global configuration command) to avoid a double-termination situation upon 
router reboot. If the MWR 1941-DC is not being used in a redundant configuration and EADI 
is specifically required, you can re-enable EADI using the no disable-eadi global configuration 
command.
When attaching the MWR 1941-DC to a device that uses spanning tree, portfast must be 
configured on the device to avoid problems with HSRP at startup.