Cisco Cisco TelePresence MX700 Referências técnicas
D15335.04
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.2, JUNE 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
124
Cisco TelePresence MX700 and MX800
API Reference Guide
xCommand Cameras SpeakerTrack Whiteboard SetDistance
Set the cameras distance to the whiteboard. This information is needed by the SpeakerTrack 60
to frame the whiteboard automatically.
Requires user role: ADMIN, USER
USAGE:
xCommand Cameras SpeakerTrack Whiteboard SetDistance Distance:
Distance
[WhiteboardId:
WhiteboardId
]
where
Distance: Integer (0..65534)
Set distance to whiteboard in centimeters. Use a distance between 0-2000 cm. Use an
accurate measurement for the feature to work seamlessly.
WhiteboardId: Integer (1..8)
The id set for the camera position used for the snap-to-whiteboard feature. Currently
only id 1 can be used.
xCommand Cameras SpeakerTrack Whiteboard StorePosition
Store the position of one of the cameras on a SpeakerTrack 60 as the Snap to Whiteboard
position. Frame the image so that there is room around the whiteboard for the speaker. To use
the Snap to Whiteboard feature it must be enabled with xConfiguration Cameras SpeakerTrack
Whiteboard Mode and tracking must be enabled with xConfiguration Cameras SpeakerTrack
Mode.
Note: You must store a snap-to-whiteboard position for both cameras.
Note: You must store a snap-to-whiteboard position for both cameras.
Requires user role: ADMIN, USER
USAGE:
xCommand Cameras SpeakerTrack Whiteboard StorePosition Camera:
Camera
[WhiteboardId:
WhiteboardId
]
where
Camera: Left/Right
Select the camera which position you wish to store.
WhiteboardId: Integer (1..8)
You can give the position an id number. Currently the only id that can be used is 1.
Conference commands
xCommand Conference DoNotDisturb Activate
This command switches on the Do Not Disturb mode, and the Timeout parameter allows you to
control when it is switched off again. When Do Not Disturb is switched on, all incoming calls are
rejected and registered as missed calls. The calling side receives a busy signal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Activate [Timeout:
Timeout
]
where
Timeout: Integer (1..1440)
Set the number of minutes before Do Not Disturb is switched off. If not set, Do Not
Disturb times out after 1440 minutes (24 hours).
xCommand Conference DoNotDisturb Deactivate
Switch off the Do Not Disturb mode. When Do Not Disturb is switched off incoming calls come
through as normal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Deactivate
xCommand Conference SpeakerLock Release
Releases locked speaker set by xCommand Conference SpeakerLock Set. Default voice
switching is switched back on.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference SpeakerLock Release
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand