Cisco Cisco C880 M4 Server Guia Da Instalação
9.Fault Clearing
39
Fault Status LED
9.1.3.
9.1.3.1. Fault status LED is on during operation
Hardware error detected (on); ServerView detected a fault (blinking), check ServerView for service action.
Storage Subsystem Switches OFF
9.1.4.
Temperature too high
The temperature sensors have measured an extreme temperature (tolerable temperature for operation
see
section
) and the server has shut down the system.
Wait until the storage subsystem has cooled down.
System does not Start Up after New Drives have been Installed
9.1.5.
SAS configuration incorrect (RAID controller)
Call up the configuration menu and check the drive settings (device configuration) and the additional
settings (advanced configuration options).
Ready LED of the Hard Disk Drive does not Come ON
9.1.6.
Check whether the hard disk drive has been correctly installed and locked (see
section
Hard disk drive or backplane is defective
Replace the hard disk drive. If the ready LED is still OFF, the backplane is defective. Contact the
service organization.