Cisco Cisco DWDM Transceiver Modules Guia Da Instalação
15
Cisco 10-Gigabit Ethernet XENPAK Transceiver Modules Installation Note
78-15665-07
Removing the XENPAK Transceiver
Figure 3
Cabling an Optical XENPAK Transceiver Module
Figure 4
Cabling a CX4 (Copper) XENPAK Transceiver Module
Removing the XENPAK Transceiver
Caution
The 10-Gigabit XENPAK transceiver is a static-sensitive device. Always use an ESD wrist strap or
similar individual grounding device when handling the XENPAK transceivers or coming into contact
with the modules.
similar individual grounding device when handling the XENPAK transceivers or coming into contact
with the modules.
If you are removing a 10-Gigabit XENPAK transceiver, follow these steps:
Step 1
Disconnect the network fiber-optic cable from the 10-Gigabit XENPAK transceiver connectors.
Immediately reinstall the dust plugs in the XENPAK transceiver optical bores and the fiber-optic cable
SC connectors.
Immediately reinstall the dust plugs in the XENPAK transceiver optical bores and the fiber-optic cable
SC connectors.
Step 2
Loosen the two captive installation screws that secure the XENPAK to the module.
1
LINK
LINK
ACTIVE
2
130145
RX
TX
Network interface
cable
SC connector
XENPAK
130146
4X InfiniBand
connector
CAB-INF-28G-5
XENPAK-10GB-CX4