Cisco Cisco MGX 8220 Modules Manual Técnico
CESM−8 Unstructured Data Transport
Document ID: 22236
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Synchronous Clocking
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Synchronous Clocking
Synchronous Residual Time Stamp (SRTS) Clocking
Adaptive Clocking
Framing on VC Disconnect
Command List
Verify
Troubleshoot
Related Information
Adaptive Clocking
Framing on VC Disconnect
Command List
Verify
Troubleshoot
Related Information
Introduction
This document provides configuration examples for unstructured data transport on the Circuit Emulation
Service Module−8 (CESM−8) card.
Service Module−8 (CESM−8) card.
Prerequisites
Requirements
Before attempting this configuration, ensure that you are knowledgeable of:
Cisco CESM−8
•
Cisco MGX 8220
•
Cisco MC3810
•
Components Used
The information in this document is based on these software and hardware versions:
MGX 8220/8250 firmware 4.1.x and later supports the CESM−8T1E1 card set
•
All configuration examples in this document are based on a CESM−8 card with this
firmware/bootcode/hardware revision:
firmware/bootcode/hardware revision:
wss−mgxb.1.10.CESM.a > dspcd
ModuleSlotNumber: 10
FunctionModuleState: Active
FunctionModuleType: CESM−8T1
FunctionModuleSerialNum: 754950
FunctionModuleHWRev: aa