Cisco Cisco Content Switching Module Manual Técnico
DNS Probes on the Content Switching Module
Configuration Example
Configuration Example
Document ID: 60045
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Configurations
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure
Configurations
Verify
Troubleshoot
Related Information
Introduction
This document provides a sample configuration of DNS probes on the Content Switching Module (CSM).
DNS probes are used to query DNS servers for specific domain names. DNS probes check the response
against a preconfigured value to determine whether or not the CSM should continue to use the server.
DNS probes are used to query DNS servers for specific domain names. DNS probes check the response
against a preconfigured value to determine whether or not the CSM should continue to use the server.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on the CSM version 3.x or higher .
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
Configure
In this section, you are presented with the information to configure the features described in this document.
Note: To find additional information on the commands used in this document, use the Command Lookup
Tool (registered customers only) .
Tool (registered customers only) .