Cisco Cisco Unified MeetingPlace 5.3 Guia De Configuração Rápida
Configuring Call Control for Cisco Unified MeetingPlace
How to Configure Call Control for Voice Conferencing
5
Related Topics
•
module
•
module
What to Do Next
Proceed to the
.
Configuring Cisco Unified Communications Manager 6.x or a Later Release:
Route Patterns
Route Patterns
Route patterns enable Cisco Unified Communications Manager to route calls to Cisco Unified
MeetingPlace by associating phone numbers with the SIP trunk.
MeetingPlace by associating phone numbers with the SIP trunk.
Before You Begin
•
Complete the
•
Write down each of the following phone numbers from the Cisco Unified MeetingPlace
Administration Center:
Administration Center:
–
Access phone numbers configured on the
–
Direct Inward Dial (DID) numbers—only if you enable DID through the
field
•
You perform this task in the Cisco Unified Communications Manager Administration pages.
Because the pages and menus vary by release, you should check the Cisco Unified
Communications Manager Administration online help for step-by-step instructions that are specific
to your release.
Because the pages and menus vary by release, you should check the Cisco Unified
Communications Manager Administration online help for step-by-step instructions that are specific
to your release.
Procedure
Step 1
Go to http://ccm-server/, where ccm-server is the fully-qualified domain name or IP address of the
Cisco Unified Communications Manager server.
Cisco Unified Communications Manager server.
Step 2
Log in with your Cisco Unified Communications Manager administrator username and password.
Step 3
Select Call Routing > Route/Hunt > Route Pattern.
Step 4
Select Add New.
Step 5
Configure the fields described in