Cisco Cisco Prisma II EDR Receiver Guia Da Instalação
Chapter 2 Module Installation
54
Installing the Module in the Chassis
To Install the Receiver Modules in the Host Module
Note:
All Prisma II high-density application modules must be installed in a host
module before they can be mounted in a standard Prisma II Chassis.
module before they can be mounted in a standard Prisma II Chassis.
Prisma II host modules prior to Rev C (date codes through A2006) do not
support the Controller Area Network (CAN) bus.
support the Controller Area Network (CAN) bus.
To support CAN bus redundancy, the ICIM2 must be Rev B or later.