Cisco Cisco D9824 Advanced Multi Decryption Receiver Guia Da Instalação

 

142 

78-4039426-01 Rev D 

1  From the user interface of the D9824, click Input > Conditional Access > CI 

Setup. The CI Setup page is displayed. 

 

2  Select Enable in the CI CAM QUERY Support drop-down to query the CAM 

prior to decryption to ensure that the card can be decrypted. The default is 
Disable. 

3  Select Enable in CI CAM Auto Reset to automatically reset the card. The default 

is Disable. 

4  In the CA List Management Type, select whether the Common Interface List 

Management should add and delete (AddDel) individual programs or update all 
(UpdateAll) the programs when the list changes. 
Note: Updating all the programs will cause temporary loss of service for all the 
programs when another is being modified. 

5  Select Enable in the TS/ONID Check drop-down if you want to restrict the 

incoming transport stream to the transport ID and transport original network ID 
listed below. If the incoming stream does not match the specified transport 
stream, the CAM will not decrypt. The default is Disable. 

6  If you set the TS/ONID Check to Enable, you must define the Transport ID and 

Original Network ID. If the incoming stream does not match the specified IDs 
here, the CAM will not decrypt. You can enter a value in a range from 0 to 65535. 

7  In the CAM TS Handling drop-down, select EntireTS to use the CAM to decrypt 

the entire transport stream, or select ServicesOnly to use the CAM to decrypt 
only the PIDs being used by the active services.