Cisco Cisco D9824 Advanced Multi Decryption Receiver Guia Da Instalação
Configuring Transport Stream Information
78-4039426-01 Rev D
181
Svc ID
Description
All Ch
Transmits the PSI tables for the mapped program even if the
program does not exist in the input stream.
program does not exist in the input stream.
All Ch is only valid if the PAT, NIT, SDT and PMT are set to
Regenerate.
Regenerate.
24 Select the SI Regeneration Option. This applies the PowerVu rates (consistent
with the uplink). This parameter is only used if Remapping Control is set to
None. The following table describes each PSI rate:
None. The following table describes each PSI rate:
PSI Rate
Description
Auto
Matches the generated PSI tables' output rate as the incoming rate.
MPEG Min
Transmits the generated PSI tables on the longest intervals that are
allowed by MPEG standard.
allowed by MPEG standard.
SA Std
Transmits the generated PSI tables based on PowerVu standard
intervals.
intervals.
25 The PSI Table Output Option drop-down allows the operator to specify which
PSI tables to include in the program/output stream. The following table
describes each option:
describes each option:
PSI Options
Description
Pass All
Transmits the incoming PSI Tables as is; does not modify the
content and rate.
content and rate.
Drop All
Does not transmit any PSI Tables.
Ctl By Table
The operator can click Table Options to select the output mode for
each table. The default table selections will be all pass, and only
with CDT dropped.
each table. The default table selections will be all pass, and only
with CDT dropped.
26 Select the PSI Regeneration Option drop-down, select whether to regenerate the
PSI tables. You can select Always or As Needed (only if the content has
changed).
changed).
27 If Ctl By Table was selected as the PSI Table Output Option, click Table
Options to configure the DPM table options. The DPM Table Options (MOIP)
window is displayed.
window is displayed.