Cisco Cisco Tunnel Terminating Gateway (TTG)
Call Control Profile Configuration Mode
access-restriction-data ▀
Command Line Interface Reference, StarOS Release 18 ▄
1909
access-restriction-data
Enables the operator to assign a failure code to be included in reject messages if the attach rejection is due to access
restriction data (ARD) checking in the incoming subscriber data (ISD) messages. The operator can also disable the ARD
checking behavior.
restriction data (ARD) checking in the incoming subscriber data (ISD) messages. The operator can also disable the ARD
checking behavior.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
access-restriction-data { eutran-not-allowed | failure-code cause_code | no-check }
remove access-restriction-data { failure-code | eutran-not-allowed }
remove
Removes the failure code setting or eutran-not-allowed override setting.
eutran-not-allowed
Overrides the eutran-not-allowed flag received in ISD/ULA messages from the HLR/HSS received during the
Attach process. The overridden value will be sent to the RNC during PDP context activation (in RAB
Assignment Request messages) so that the RNC subsequently avoids performing a handover to E-UTRAN.
Configuration of the
Attach process. The overridden value will be sent to the RNC during PDP context activation (in RAB
Assignment Request messages) so that the RNC subsequently avoids performing a handover to E-UTRAN.
Configuration of the
eutran-not-allowed
parameter is valid only if SRNS relocation first has been
configured in Call Control Profile Configuration Mode via the
srns-inter
and/or
srns-intra
commands.
The call-control-profile then must be associated with an operator policy in Operator Policy Configuration
Mode using the
Mode using the
associate
command. Once the operator policy is associated with the call-control-profile,
inclusion of the E-UTRAN Service Handover Information Element in RAB Assignment Request and
Relocation Request RANAP messages must be enabled. This is done by executing the
Relocation Request RANAP messages must be enabled. This is done by executing the
ranap eutran-
service-handover-ie
command in RNC Configuration Mode.
failure-code
cause_code
cause_code
: Enter an integer from 2 through 111; default code is 13 (roaming not allowed in this location
area [LA]).
Refer to the GMM failure cause codes listed below (from section 10.5.5.14 of the 3GPP TS 124.008 v7.2.0
R7):
Refer to the GMM failure cause codes listed below (from section 10.5.5.14 of the 3GPP TS 124.008 v7.2.0
R7):
2 - IMSI unknown in HLR
3 - Illegal MS
6 - Illegal ME
7 - GPRS services not allowed