Cisco Cisco Aironet 340 Ethernet Bridges

You must have a 340, 500, or 4800 series bridge or a 4800 series access  point to install firmware version 
8.24_2.

Your bridge or access point must have version 7.0 or later to upgrade to version 8.24_2.

The firmware version number appears in the top left corner of the screen in the browser-based 
management system. To view the browser-based management system, type the device’s IP address in 
your Internet browser’s address line.

Follow these steps to upgrade the firmware in your bridge or access point:

Use one of the following URLs to find firmware version 8.24_2:

http://www.cisco.com/pcgi-bin/tablebuild.pl/aironet-4800

or

http://www.cisco.com/pcgi-bin/tablebuild.pl/aironet-340

In the Filename column, click [firmware version 8.24_2]. Follow the instructions for saving the file to 
your local drive.

Use an Internet browser to open the management system on the bridge or access point. To browse to the 
management system, type the bridge’s or access point’s IP address in the browser’s address line and 
press Enter.

When the management system opens, click Allow Config Changes in the top left corner of the page. 

Click Load in the Diagnostics column near the top of the page.

In the Value column, click Browse. Find the local drive where you saved the new firmware version and 
select the firmware file.

Click Send. The new firmware is loaded and the bridge or access point reboots.