Cisco Cisco Token Ring Port Adapters Guia De Informação
Cisco Systems, Inc.
All contents are Copyright © 1992–2005 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
Page 1 of 3
End-of-Life Notice, No. 2972
End-of-Sale and End-of-Life Announcement for the Cisco PA-POS-OC3MM,
PA-POS-OC3SML, PA-POS-OC3SMI and Transition to the New PA-POS-1OC3
PA-POS-OC3SML, PA-POS-OC3SMI and Transition to the New PA-POS-1OC3
Cisco Systems
®
announces the end-of-sale and end-of-life dates for the Cisco
®
PA-POS-OC3MM, PA-POS-OC3SML, PA-POS-OC3SMI
and transition to the new PA-POS-1OC3 with pluggable optics. The last day to order the PA-POS-OC3MM, PA-POS-OC3SML, and
PA-POS-OC3SMI is July 31, 2006. Customers with active service contracts will continue to receive support from the Cisco Technical
Assistance Center (TAC) until July 31, 2011. Table 1 describes the end-of-life milestones, definitions, and dates for the affected product.
Table 2 lists the product part numbers affected by this announcement. This end of sale announcement affects all Cisco platforms that support
these port adapters. The platforms affected are the Cisco 7200, 7301, 7304, 7500, 7600, uBR7200 series routers.
Customers are encouraged to migrate to the PA-POS-1OC3, which has been shown to provide higher-performance characteristics for better
utilization of OC3 connectivity, as well as the ability to use the Small Form-Factor Pluggable optics, hence, reducing the total cost of ownership
for our customers. Information about the replacement product can be found at:
http://www.cisco.com/en/US/products/hw/modules/ps2033/ps2843/index.html
Table 3 provides relevant information for migrating from the Cisco PA-POS-OC3MM, PA-POS-OC3SML and PA-POS-OC3SMI to the
PA-POS-1OC3.
Table 1.
End-of-Life Milestones and Dates for the Cisco PA-POS-OC3MM, PA-POS-OC3SML, and PA-POS-OC3SMI
Milestone
Definition
Date
End-of-Life Announcement Date
The date the document that announces the end of sale and end of life of a
product is distributed to the general public.
product is distributed to the general public.
August 1, 2005
End-of-Sale Date
The last date to order the product through Cisco point-of-sale mechanisms.
The product is no longer for sale after this date.
The product is no longer for sale after this date.
July 31, 2006
Last Ship Date
The last-possible ship date that can be requested of Cisco and/or its contract
manufacturers. Actual ship date is dependent on lead time.
manufacturers. Actual ship date is dependent on lead time.
October 30, 2006
End of SW Maintenance
Releases Date
Releases Date
The last date that Cisco Engineering may release any final software
maintenance releases or bug fixes. After this date, Cisco Engineering will no
longer develop, repair, maintain, or test the product software.
maintenance releases or bug fixes. After this date, Cisco Engineering will no
longer develop, repair, maintain, or test the product software.
July 31, 2007
End of Routine Failure Analysis Date
The last-possible date a routine failure analysis may be performed to
determine the cause of product failure or defect.
determine the cause of product failure or defect.
July 31, 2007
End of New Service Attachment Date
For equipment and software that is not covered by a service-and-support
contract, this is the last date to order a new service-and-support contract or
add the equipment and/or software to an existing service-and-support contract.
contract, this is the last date to order a new service-and-support contract or
add the equipment and/or software to an existing service-and-support contract.
July 31, 2007
End of Service Contract Renewal Date
The last date to extend or renew a service contract for the product.
January 29, 2011
Last Date of Support
The last date to receive service and support for the product. After this date,
all support services for the product are unavailable, and the product becomes
obsolete.
all support services for the product are unavailable, and the product becomes
obsolete.
July 31, 2011