Cisco Cisco 12000 Series 12-Port DS3 Line Card Guia De Resolução De Problemas
Configuring a Core Dump on a GSR Line Card
Document ID: 12769
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure and Test Core Dump
Core Dump
Configuration
Test the Setup
Optional Commands
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure and Test Core Dump
Core Dump
Configuration
Test the Setup
Optional Commands
Related Information
Introduction
This document provides instructions on how to configure a core dump on a Cisco Gigabit Switch Router
(GSR) line card (LC).
(GSR) line card (LC).
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software and hardware versions:
Cisco IOS® Software Release 12.0(24)S1
•
This document applies to all Cisco 12xxx series GSR routers
•
Caution: A core dump to the remote server can take anywhere from 20 to 45 minutes. The router is
inaccessible and does not forward packets at this time. Use this procedure with caution.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
Configure and Test Core Dump