Cisco Cisco Agent Desktop 10.5 Guia Da Instalação
Cisco CAD Installation Guide
62
August 8, 2012
NOTE: If you change these settings after initial setup, you must
restart the all CAD services to ensure that the change is registered
with them properly.
restart the all CAD services to ensure that the change is registered
with them properly.
To set up the user ID and password, see
SNMP Configuration
Figure 19.
SNMP Configuration window.
The SNMP Configuration window appears only during the Update mode if the
Microsoft Simple Network Management Protocol (SNMP) Service is installed on the
CAD services server.
Microsoft Simple Network Management Protocol (SNMP) Service is installed on the
CAD services server.
If you select the Enable SNMP Trap Generation check box, INFO and higher error
messages are sent from the CAD services server to the IP addresses configured in the
Destination pane. Use the Add, Edit, and Remove buttons to manage the list of
destination IP addresses.
messages are sent from the CAD services server to the IP addresses configured in the
Destination pane. Use the Add, Edit, and Remove buttons to manage the list of
destination IP addresses.
The SNMP Service can be installed using the Add/Remove Windows Components
button in the Add or Remove Programs utility in Control Panel (select Management
and Monitoring Tools from the list of available components, and then choose Simple
Network Management Protocol).
button in the Add or Remove Programs utility in Control Panel (select Management
and Monitoring Tools from the list of available components, and then choose Simple
Network Management Protocol).