Cisco Cisco TelePresence MX700 Guia Da Instalação
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
28
GettinG started Guide
Web interface
Configuring H.323 and SIP
To get online and ready to place and receive calls, your
system must be set up properly. Your system will use either
the H.323 protocol or the SIP protocol for video calls.
NOTE:
Contact your system administrator, or service
provider, for information about the network settings.
For networks administered through Cisco TMS (Cisco
TelePresence Management Suite) your Cisco TMS
administrator will help you to get online.
H.323
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to the
Configuration
tab and select
Advanced
Configuration
.
Click on
H323
and then on
Profile 1
.
2. Click on
H323 Alias
and enter the
ID
and
E164
number
in their respective input fields.
3. Click on
Gatekeeper.
If you want the system to obtain the H.323 gatekeeper
address automatically, select
Auto
in the
Discovery
drop
down list; if you want to enter the address manually,
select
Manual.
If set to
Manual
enter the gatekeeper
Address
in the
corresponding input field.
4. If the H.323 gatekeeper requires authentication and
you want your system to authenticate itself to the
gatekeeper, click on
Authentication
and select
On
in the
Mode
drop down list. Then enter the
LoginName
and
Password
in the corresponding input fields.
Otherwise, select
Off
in the
Mode
drop down list.
5. Go to the
Diagnostics
tab and select
System Information
to verify the H323 settings.
If you successfully registered to a SIP server the
If you successfully registered to a SIP server the
Status
will show
Registered
in the H323 section.
Please check the
Administrator guide
for your product if you
want to change the other H.323 settings.
SIP
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to the
Configuration
tab and select
Advanced
Configuration
.
Click on
SIP
and then on
Profile 1
.
2. Enter the SIP URI in the
URI 1
input field, and optionally a
display name in the
DisplayName
input field.
3. Select the preferred transport protocol from the
DefaultTransport
drop down list. If you select
Auto
, the
system will first try to connect using TLS, then TCP, and
finally UDP.
4. Select a proxy type in the
Type
drop down list. The
default type is
Standard
.
5. Click on
Proxy 1.
If you want the system to obtain the SIP proxy address
automatically, select
Auto
in the
Discovery
drop down
list; if you want to enter the address manually, select
Manual
.
If you select
Manual
enter the proxy
Address
in the
corresponding input field.
6. If the SIP proxy requires authentication you must enter a
login name and password to authenticate your system.
Click
Authentication 1
and enter the
LoginName
and
Password
in the corresponding input fields.
7. Go to the
Diagnostics
tab and select
System Information
to verify the SIP settings.
If you successfully registered to a SIP server the
If you successfully registered to a SIP server the
Status
will show
Registered
in the SIP section.
Please check the
Administrator guide
for your product if you
want to change the other SIP settings.
Save the new value when you change a setting
Click
ok
to save the change, or
cancel
to leave
without saving.
User interfaces
Introduction
Configuration
Table of contents
Appendices
Configuration