Cisco Cisco TelePresence MX700 Manual De Manutenção
Adding a new phone (endpoint) continued...
Configuring shared lines
Optional:
To configure the CUCM for shared lines, navigate
back to
and repeat the steps for manual registration of another
endpoint and assign the next endpoint to the
same
directory
number.
Associated Devices:
When one directory number has been set up to be shared
between more than one endpoint you will see the MAC
addresses of the devices listed in the
Associated Devices
section.
Additionally you must set the
Privacy
setting to
Off
for shared
lines to function as intended. You can find this setting under
Device > Phone > Phone Configuration > Device Information
.
Display caller name
Optional
: Navigate to the
Line # on Device <MAC address>
section.
Display (Caller ID):
Enter the TelePresence system's owner's name to allow
the receiver of a call from the system to see the proper
identity of the caller.
Display text for a line appearance is inteded for displaying
Display text for a line appearance is inteded for displaying
text, such as a name, instead of a directory number for
calls. If you specify a number, the person receiving a call
from this device may not see the callers proper identity.
When done click
Save
and
Apply Config
.
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Deployment Guide
D15336.01 Deployment gude for TelePresence Endpoints on CUCM, DECEMBER 2015.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
21
Contents
Introduction
CUCM configuration
Endpoint configuration
Appendices
Contact
CUCM configuration