Cisco Cisco TelePresence MX700 Manual De Manutenção

D15331.04 MX700 and MX800 Administrator Guide CE8.2, OCTOBER 2016.  

www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

73

Cisco TelePresence MX700 and MX800

 Administrator Guide

Network (LAN)

Connect the Touch 10 controller 

(page 2 of 3)

1 

If the network infrastructure provides 

Power over Ethernet (PoE), you do not 

need a PoE injector; Touch 10 should 

be connected directly to the wall socket 

(Ethernet switch) with a PoE rated 

Ethernet cable.

 

For safety, the PoE source must be in 

the same building as Touch 10. The PoE 

rated Ethernet cable can be up to 100 m 

(330 ft).

Contact information

The video system’s 

name or address is 

displayed in the status 

bar when Touch 10 is 

successfully paired to 

the video system.

AP

SWITCH

The Ethernet connector 

is behind the lid at the 

rear of Touch 10. 

PoE rated Ethernet cable

Power 

• 100-240 VAC 

• 50/60 Hz

Network (LAN)

1

Standard Ethernet cable

Standard Ethernet cable

Connect Touch 10 to the video system 

via the network (LAN)

Connect Touch 10 and the video system to network wall 

sockets or to a network switch as illustrated.

Touch 10 set-up 

Once Touch 10 is connected to power, the set-up 

procedure begins. Follow the instructions on screen.

When the 

 screen appears, note the 

following:

•  A list of video systems signalling that they are available 

for paring will show up on the screen. Tap the name of 

the system you want to pair with. 
Note that the following must be fulfilled for a video 

system to show up in the list:

•  The video system and Touch 10 must be on the 

same subnet.

•  The video system must have been restarted within 

the last 10 minutes. If the video system does not 

appear in the list, try restarting it.

•  If the video system does not appear in the list of 

available systems, enter its IP address or hostname in 

the input field. Tap 

 or 

.

•  You have to log in with username and passphrase 

for the paring process to commence. Tap 

 or 

.

A user with the USER role is sufficient; you do not need 

the ADMIN role to perform this task. 

Read more about how to create a user account and 

assign a role to it in the 

 chapter.

If Touch 10 needs software upgrade, new software will 

be downloaded from the video system and installed on 

the unit automatically as part of the set-up procedure. 

Touch 10 restarts after the upgrade.

Introduction

Configuration

Peripherals

Maintenance

System settings

Appendices



Peripherals