Cisco Cisco TelePresence MX700 Manual De Manutenção

D15331.04 MX700 and MX800 Administrator Guide CE8.2, OCTOBER 2016.

Cisco TelePresence MX700 and MX800

Administrator Guide

Audio settings

Audio DefaultVolume

Define the default volume for the speakers. The volume is set to this value when you switch

on or restart the video system. Use the Touch controller to change the volume while the

video system is running. You may also use API commands (xCommand Audio Volume) to

change the volume while the video system is running, and to reset to default value.

Requires user role: ADMIN, USER
Default value: 50

Value space: Integer (0..100)

Select a value between 1 and 100. This corresponds to the dB range from -34.5 dB to

15 dB, in steps of 0.5 dB). If set to 0 the audio is switched off.

Audio Microphones Mute Enabled

Define the microphone mute behaviour on the video system.

Requires user role: ADMIN
Default value: True

Value space: True/InCallOnly

True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is

not possible to mute the microphone. This is useful when an external telephone service/

audio system is connected via the codec and is to be available when the codec is not

in a call. When set to InCallOnly this will prevent the audio-system from being muted by

mistake.

Audio MicrophoneReinforcement Input Microphone [1..8] Mode

Set the microphone reinforcement mode individually on each microphone. The

signals from all microphones with Mode = On will be mixed and fed to the selected

MicrophoneReinforcement outputs. Also consult the Audio MicrophoneReinforcement

Output Line Mode setting.

Requires user role: ADMIN
Default value: Off

Value space: Off/On

On: The microphone signal will be fed to the selected MicrophoneReinforcement

outputs, as well as to the far end.
Off: The microphone signal will be sent only to the far end. It will not be fed to the

selected MicrophoneReinforcement outputs.

Audio MicrophoneReinforcement Output Line [1..4] Mode

Set the microphone reinforcement mode individually on each line output. If Mode = On, the

line output will add the microphone reinforcement mix to its ordinary output signal. Also

consult the Audio MicrophoneReinforcement Input Microphone Mode setting.

Requires user role: ADMIN
Default value: Off

Value space: Off/On

On: This output will deliver far end audio, local presentation audio and the microphone

reinforcement mix.
Off: This output will deliver far end audio and local presentation audio.

Introduction

Configuration

Peripherals

Maintenance

System settings

Appendices



System settings