Cisco Cisco TelePresence MX700 Manual De Manutenção

D14850.13 MX200 and MX300 Administrator Guide TC7.3, OCTOBER 2015.

Cisco TelePresence MX200 and MX300

Administrator Guide

Cameras Camera [1] Focus Mode

Set the camera focus mode.

Requires user role: ADMIN
Value space: <Auto/Manual>

Auto: The camera will auto focus once a call is connected, as well as after moving the

camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set the

right focus; then auto focus is turned off to prevent continuous focus adjustments of the

camera.
Manual: Turn the autofocus off and adjust the camera focus manually.

Example:

Cameras Camera 1 Focus Mode: Auto

Cameras Camera [1] Gamma Mode

This setting enables gamma corrections. Gamma describes the nonlinear relationship between

image pixels and monitor brightness.

Requires user role: ADMIN
Value space: <Auto/Manual>

Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref:

Cameras Camera [1..n] Gamma Level.

Example:

Cameras Camera 1 Gamma Mode: Auto

Cameras Camera [1] Gamma Level

By setting the Gamma Level you can select which gamma correction table to use. This setting

may be useful in difficult lighting conditions, where changes to the brightness setting does not

provide satisfactory results. Requires the Gamma Mode to be set to Manual.

Requires user role: ADMIN
Value space: <0..7>

Range: Select a value between 0 and 7.

Example:

Cameras Camera 1 Gamma Level: 0

Cameras Camera [1] Mirror

Not applicable for this product.

Cameras Camera [1] Whitebalance Mode

Set the camera white balance mode.

Requires user role: ADMIN
Value space: <Auto/Manual>

Auto: The camera will continuously adjust the white balance depending on the camera view.
Manual: Enables manual control of the camera white balance. The white balance level is set

using the Cameras Camera Whitebalance Level setting.

Example:

Cameras Camera 1 Whitebalance Mode: Auto

Cameras Camera [1] Whitebalance Level

Set the white balance level. Requires the Camera Whitebalance Mode to be set to manual.

Requires user role: ADMIN
Value space: <1..16>

Range: Select a value between 1 and 16.

Example:

Cameras Camera 1 Whitebalance Level: 1

Contents

Introduction

System settings

Setting passwords

Appendices

Web interface

System settings