Cisco Cisco TelePresence MX700 Folheto

Cisco TelePresence Endpoints running TC6 and Cisco Unified Communications Manager 9.0 

Quick Reference Guide

D14996.01 Administering TC6 Endpoints on CUCM 9.0, January 2013. 

www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved. 

9

Touch

Setting up provisioning

Provisioning allows the video conferencing network 

administrators to manage many video systems 

simultaneously. In general, you only have to input the 

credentials of the provisioning server to each video system; 

the rest of the configuration is done automatically.

Contact your Cisco Unified CM (CUCM) provider if in doubt 

for any of the provisioning parameters.

About the External Manager address
If the network does not offer DHCP Option 150, the External 

Manager Address must be added manually. Note that any 

input in the field will override the setting provided by DHCP.

When the infrastructure is set to Cisco UCM; then CDP (Cisco 

Discovery Protocol) will be enabled and if CDP is successful, 

the endpoint will discover DHCP Option 150. In this case you 

can leave the External Manager Address field blank, as the 

DHCP server will provide the address automatically. 

About the CTL file
Normally, you will not delete the old Certificate Trust List 

(CTL), but there are few cases were you will need to delete 

the file from the endpoint such as:

•  When changing the CUCM IP address.
•  When moving the endpoint between CUCM clusters.
•  When you need to re-generate or change the CUCM 

certificate.

Running the Provisioning Wizard
If you are connecting the system for the first time, the 

Provisioning Wizard will start automatically. Otherwise, tap 

.

Run the provisioning wizard

1.  Click the 

 button.

2.  Choose 

 infrastructure and click 

.

3.  If required: Enter the IP address or DNS name of the 

External Manager of the Cisco UCM cluster TFTP server 

in the 

 input field. A soft keyboard 

appears when you tap the field.

4.  If required: Check the 

 check box. If no CTL file exist on the endpoint, 

this option will not be available.

5.  Tap 

 to complete the registration, or 

 to 

abort the procedure.

6.  When successfully registered a message will appear and 

display the URI for the endpoint.

Setting up provisioning
If the system is in sleep mode, press any key on the remote 

control to wake up the system.

Configure the provisioning

1.  Use the remote control and select 

.

2.  From the drop down list, set the 

 to 

CUCM. The change will take effect immediately.

3.  Go to the 

 section and the IP address 

or DNS name of the External Manager of the Cisco UCM 

cluster TFTP server in the 

 input field. 

Click 

 to save the changes.

OSD 

Contents

Introduction

Endpoint configuration

CUCM configuration

Setting passwords

Appendices

Endpoint configuration