Cisco Cisco Firepower Management Center 2000 Guia Da Instalação

      

  Restoring a Firepower Management Center to Factory Defaults

Firepower Management Center Getting Started Guide

sudo /usr/local/sf/bin/configure_console.sh vga

To access the appliance using the physical serial port: 

sudo /usr/local/sf/bin/configure_console.sh serial

To access the appliance using LOM via SOL: 

sudo /usr/local/sf/bin/configure_console.sh sol

To implement your changes, reboot the appliance by typing 

sudo

 

reboot

.

The appliance reboots.

Using the Web Interface to Redirect the Console Output

Select 

Select 

Select a remote console access option:

Select 

to use the appliance's VGA port. This is the default option.

Select 

 to use the appliance's serial port, or to use LOM/SOL on a Management Center.

If you selected 

, the LOM settings appear. 

To configure LOM via SOL, enter the appropriate settings:

 for the appliance (

 or 

).

to be used for LOM. The LOM IP address must be different from the management interface IP 

address of the appliance.

for the appliance. 

for the appliance. 

Click 

.

Remote console configuration for the appliance is saved. If you configured Lights-Out Management, you must 
enable it for at least one user; see 

Restoring a Firepower Management Center to Factory 
Defaults

Cisco provides ISO images on its Support Site for restoring, or reimaging, Firepower Management Centers to their 
original factory settings.

For more information, see the following sections:











