Cisco Cisco Firepower Management Center 2000 Manual Técnico
Install and Configure a FirePOWER Services
Module on an ASA Platform
Module on an ASA Platform
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
Before You Begin
Install
Install the SFR Module on the ASA
Set Up the ASA SFR Boot Image
Configure
Configure the FirePOWER Software
Configure the FireSIGHT Management Center
Redirect Traffic to the SFR Module
Verify
Troubleshoot
Related Information
Introduction
This document describes how to install and configure a Cisco FirePOWER (SFR) module that runs
on a Cisco Adaptive Security Appliance (ASA) and how to register the SFR module with the Cisco
FireSIGHT Management Center.
on a Cisco Adaptive Security Appliance (ASA) and how to register the SFR module with the Cisco
FireSIGHT Management Center.
Prerequisites
Requirements
Cisco recommends that your system meet these requirements before you attempt the procedures
that are described in this document:
that are described in this document:
Ensure that you have at least 3GB of free space on the flash drive (disk0), in addition to the
size of the boot software.
size of the boot software.
●
Ensure that you have access to the privileged EXEC mode. In order to access the privileged
EXEC mode, enter the enable command into the CLI. If a password was not set, then press
Enter:
EXEC mode, enter the enable command into the CLI. If a password was not set, then press
Enter:
ciscoasa> enable Password: ciscoasa#
●
Components Used