Cisco Cisco IOS Software Releases 12.2 MC
3
Release Notes for Cisco MWR 1941-DC Mobile Wireless Edge Router for Cisco IOS Release 12.2(15)MC2g
OL-13984-16
System Configuration Requirements
•
Cisco Express Forwarding (CEF)
You cannot disable CEF on the MWR 1941-DC. Commands such as no ip cef will display an error
message “%Cannot disable CEF on this platform.” Some commands, such as no ip route-cache cef,
will not return an error message, however, CEF will not be disabled regardless of whether or not an
error message is displayed.
message “%Cannot disable CEF on this platform.” Some commands, such as no ip route-cache cef,
will not return an error message, however, CEF will not be disabled regardless of whether or not an
error message is displayed.
•
Hot Standby Router Protocol
(
HSRP)
In case of a tie in priority, HSRP uses the IP address to determine the active router. Therefore, you
should ensure that the order of the IP addresses of the E1/T1 interfaces of the active router
corresponds to the order of the IP addresses of the E1/T1 interfaces of the standby router.
should ensure that the order of the IP addresses of the E1/T1 interfaces of the active router
corresponds to the order of the IP addresses of the E1/T1 interfaces of the standby router.
Memory Recommendations
Determining the Software Version
To determine the version of Cisco IOS software running on your Cisco MWR 1941-DC router, log in to
the Cisco MWR 1941-DC and enter the show version EXEC command:
the Cisco MWR 1941-DC and enter the show version EXEC command:
router> show version
Cisco Internetwork Operating System Software
IOS (tm) 1900 Software (MWR1900-I-MZ), Version 12.2(15)MC2a, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)
Upgrading to a New Software Release
For general information about upgrading to a new software release, refer to Software Installation and
Upgrade Procedures located at the following URL:
Upgrade Procedures located at the following URL:
Upgrading to a New ROM Monitor Version
The Cisco MWR 1941-DC router ROM Monitor (ROMMON) consists of two modules:
•
A resident module that is not changed during the upgrade procedure.
•
An upgradable module that is updated during the upgrade procedure. This is the only module that
you will download from Cisco.com.
you will download from Cisco.com.
Note
Before performing this procedure, you must download the new ROMMON image from Cisco.com. The
download procedure is the same as downloading Cisco IOS software images.
download procedure is the same as downloading Cisco IOS software images.
Table 1
Memory Recommendations for the Cisco MWR 1941-DC Mobile Wireless Edge Router
Platform
Software Image
Flash
Memory
Recommended
Memory
Recommended
DRAM
Memory
Recommended
Memory
Recommended
Runs From
Cisco MWR 1941-DC router
mwr1900-i-mz
32 MB Flash
128 MB DRAM
RAM