Cisco Cisco IOS Software Releases 12.2 MC
8
Release Notes for Cisco MWR 1941-DC Mobile Wireless Edge Router for Cisco IOS Release 12.2(15)MC2g
OL-13984-16
Limitations, Restrictions, and Important Notes
Note
For complete details of the ACFC and PFC Handling During PPP Negotiation feature, see the ACFC and
PFC Handling During PPP Negotiation feature module:
PFC Handling During PPP Negotiation feature module:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122b/122b_15/1
2b_acf.htm#1025043
2b_acf.htm#1025043
Configuring the cUDP Flow Expiration Timeout Duration
To minimize traffic flow corruption, cUDP flows now expire after an expiration timeout duration during
which no packets are passed. When this duration of inactivity occurs on a flow at the compressor, the
compressor sends a full header upon receiving a packet for that flow, or, if no new packet are received
for that flow, makes the CID for the flow available for new use. When a packet is received at the
decompressor after the duration of inactivity, the packet is dropped and a context state message is sent
to the compressor requesting a flow refresh.
which no packets are passed. When this duration of inactivity occurs on a flow at the compressor, the
compressor sends a full header upon receiving a packet for that flow, or, if no new packet are received
for that flow, makes the CID for the flow available for new use. When a packet is received at the
decompressor after the duration of inactivity, the packet is dropped and a context state message is sent
to the compressor requesting a flow refresh.
The default expiration timeout is 5 seconds. The recommended value is 8 seconds.
Caution
Failure of performance/latency scripts could occur if the expiration timeout duration is not changed to
the recommended 8 seconds.
the recommended 8 seconds.
To configure the cUDP flow expiration timeout duration, issue the following command while in
multilink interface configuration mode:
multilink interface configuration mode:
To restore the default, use the no form of this command.
This new feature is identified by CSCeb44623.
Limitations, Restrictions, and Important Notes
Caution
The Cisco MWR 1941-DC router does not support online insertion and removal (OIR) of WAN interface
cards. Any attempt to perform OIR on a card in a powered up router might cause damage to the card.
cards. Any attempt to perform OIR on a card in a powered up router might cause damage to the card.
Caution
Removing the compact flash from the Cisco MWR 1941-DC router during a read/write operation might
corrupt the contents of the compact flash, rendering it useless. To recover from an accidental removal of
or corruption to the compact flash, a maintenance spare with the appropriate bootable Cisco IOS
software image might be needed.
corrupt the contents of the compact flash, rendering it useless. To recover from an accidental removal of
or corruption to the compact flash, a maintenance spare with the appropriate bootable Cisco IOS
software image might be needed.
Command
Purpose
Router(config-if)# ppp iphc max-time seconds
Specifies the duration of inactivity, in seconds, that when
exceeded causes the cUDP flow to expire. The recommended
value is 8.
exceeded causes the cUDP flow to expire. The recommended
value is 8.