Cisco Cisco IOS Software Releases 12.2 B
Local Template-Based ATM PVC Provisioning
How to Configure Local Template-Based ATM Provisioning
3
Cisco IOS Release: Multiple releases (see the Feature History table)
Configuring ATM PVC Local Autoprovisioning in a VC Class
To enable ATM PVC local autoprovisioning in a VC class, use the following commands beginning in
global configuration mode:
global configuration mode:
A VC class configured with ATM PVC autoprovisioning can be assigned to an ATM interface, an ATM
PVC, an ATM PVC range, and an ATM PVC with a range.
PVC, an ATM PVC range, and an ATM PVC with a range.
Note
If a VC class that is configured with ATM PVC autoprovisioning is assigned to an ATM interface, all
PVCs on the interface will be autoprovisioned.
PVCs on the interface will be autoprovisioned.
Configuring ATM PVC Local Autoprovisioning on a PVC
To enable ATM PVC local autoprovisioning on a PVC, use the following commands beginning in global
configuration mode:
configuration mode:
ATM PVC local autoprovisioning can also be configured on a PVC by assigning a VC class that has been
configured with ATM PVC local autoprovisioning to the PVC.
configured with ATM PVC local autoprovisioning to the PVC.
Command or Action
Purpose
Step 1
Router(config)# vc-class atm
vc-class-name
Creates a VC class for an ATM PVC, SVC, or ATM interface and
enters ATM VC class configuration mode.
enters ATM VC class configuration mode.
Step 2
Router(config-vc-class)# create on-demand
Configures ATM PVC autoprovisioning, which enables a PVC or
range of PVCs to be created automatically on demand.
range of PVCs to be created automatically on demand.
Step 3
Router(config-vc-class)# idle-timeout
seconds [minimum-rate]
(Optional) Configures the idle timeout parameter for tearing
down ATM SVC connections or autoprovisioned ATM PVC
connections.
down ATM SVC connections or autoprovisioned ATM PVC
connections.
Command or Action
Purpose
Step 1
Router(config)# interface atm slot/port
Configures an ATM interface.
Step 2
Router(config-if)# atm autovc retry
interval
(Optional) Configures the interval at which the router will repeat
the attempt to create autoprovisioned PVCs after a failure of the
initial creation attempt.
the attempt to create autoprovisioned PVCs after a failure of the
initial creation attempt.
Step 3
Router(config-if)# pvc [name] vpi/vci
Creates an ATM PVC and enters ATM virtual circuit
configuration mode.
configuration mode.
Step 4
Router(config-if-atm-vc)# create
on-demand
Configures ATM PVC autoprovisioning, which enables a PVC or
range of PVCs to be created automatically on demand.
range of PVCs to be created automatically on demand.
Step 5
Router(config-if-atm-vc)# idle-timeout
seconds [minimum-rate]
(Optional) Configures the idle timeout parameter for tearing
down ATM SVC connections or autoprovisioned ATM PVC
connections.
down ATM SVC connections or autoprovisioned ATM PVC
connections.