Cisco Cisco 2000 Series Wireless LAN Controller
3
Release Notes for Cisco wireless LAN controller and Cisco Aironet Lightweight Access Point for Software Release 3.1.59.24
New Features
New Features
The following new features are available in the wireless LAN controller 3.1.59.24 release:
•
802.11h support
•
Enhanced support for the Cisco Wireless IP Phone 7920
•
Enhanced integration with Cisco Secure ACS
•
Location services enhancements
•
Regulatory domain updates
•
New hardware platform support: Cisco Aironet 1130 series lightweight access points, Cisco Aironet
1200 series lightweight access points, Cisco Aironet 1240 series lightweight access points, and
Cisco Aironet 1500 series lightweight outdoor access points
1200 series lightweight access points, Cisco Aironet 1240 series lightweight access points, and
Cisco Aironet 1500 series lightweight outdoor access points
For more information, refer to the following location:
Installation Notes
This section contains important information to keep in mind when installing your wireless LAN
controllers and Cisco Aironet lightweight access points.
controllers and Cisco Aironet lightweight access points.
Warnings
Warning
This warning means danger. You are in a situation that could cause bodily injury. Before you work on
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Do not locate any antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing antennas, take extreme care not
to come in contact with such circuits, as they may cause serious injury or death. For proper
installation and grounding of the antenna, refer to national and local codes (e.g. U.S.: NFPA70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
where it can come into contact with such circuits. When installing antennas, take extreme care not
to come in contact with such circuits, as they may cause serious injury or death. For proper
installation and grounding of the antenna, refer to national and local codes (e.g. U.S.: NFPA70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than:
120 VAC, 15A U.S. (240vac, 10A International)
the protective device is rated not greater than:
120 VAC, 15A U.S. (240vac, 10A International)