Cisco Cisco 5760 Wireless LAN Controller Referências técnicas
• unit—Sets the unit.
You can specify the following geo-spatial location information in geo-location configuration mode:
• altitude—Sets altitude information in units of floor, meters, or feet.
• latitude—Sets latitude information in degrees, minutes, and seconds. The range is from -90 degrees to
90 degrees. Positive numbers indicate locations north of the equator.
• longitude—Sets longitude information in degrees, minutes, and seconds. The range is from -180 degrees
to 180 degrees. Positive numbers indicate locations east of the prime meridian.
• resolution—Sets the resolution for latitude and longitude. If the resolution value is not specified, default
value of 10 meters is applied to latitude and longitude resolution parameters. For latitude and longitude,
the resolution unit is measured in meters. The resolution value can also be a fraction.
the resolution unit is measured in meters. The resolution value can also be a fraction.
• default—Sets the geographical location to its default attribute.
• exit—Exits from geographical location configuration mode.
• no—Negates the specified geographical parameters and sets the default value.
Use the no lldp med-tlv-select location information interface configuration command to disable the location
TLV. The location TLV is enabled by default.
TLV. The location TLV is enabled by default.
Examples
This example shows how to configure civic location information on the controller:
Controller(config)#
location civic-location identifier 1
Controller(config-civic)#
number 3550
Controller(config-civic)#
primary-road-name
“Cisco Way”
Controller(config-civic)#
city
“San Jose”
Controller(config-civic)#
state CA
Controller(config-civic)#
building 19
Controller(config-civic)#
room C6
Controller(config-civic)#
county
“Santa Clara”
Controller(config-civic)#
country US
Controller(config-civic)#
end
You can verify your settings by entering the show location civic-location privileged EXEC command.
This example shows how to configure the emergency location information on the controller:
Controller(config)#
location elin-location 14085553881 identifier 1
You can verify your settings by entering the show location elin privileged EXEC command.
The example shows how to configure geo-spatial location information on the controller:
Controller(config)#
location geo-location identifier host
Controller(config-geo)#
latitude 12.34
Controller(config-geo)#
longitude 37.23
Controller(config-geo)#
altitude 5 floor
Controller(config-geo)#
resolution 12.34
You can use the show location geo-location identifier command to display the configured geo-spatial location
details.
details.
Consolidated Platform Command Reference, Cisco IOS XE Release 3SE (Cisco WLC 5700 Series)
48
OL-29471-01
location